If you have cable or antenna through vcr – Sceptre X42BV-FULLHD User Manual
Page 28
SCEPTRE X42 HDTV User Manual
- 28 -
www.SCEPTRE.com
If You Have Cable or Antenna through VCR…
1. Make sure the power of X42 LCD HDTV is turned off.
2. Make sure there is an antenna or cable connection to the VCR
already.
3. Use a Coaxial RF cable and connect from your VCR’s Antenna Out
or Output to TV to the ATSC/NTSC port off the back of your X42
LCD HDTV.
4. Turn on X42 LCD HDTV.
5. Select TV (Air) for antenna or TV (Cable) for digital cable from either
your remote control’s source button or source button on the right side
of the TV.
6. Use the On Screen Display to scan for channels.
Please Note :
•
Some VCRs require you to turn it on before its output will have a signal to
the TV. Please consult your VCR manual for further reference.
•
Not all broadcasts are in High Definition (HD). Please refer to your local
broadcasting stations for more information.
•
The X42 LCD HDTV’s tuner is designed for HDTV therefore requires a
stronger signal than normal TVs. If you cannot achieve that signal level with
your antenna or cable, your X42 LCD HDTV might lose picture or sound.
•
This TV will turn off automatically if there’s no signal present for more than
15 minutes.