Scientech S200 Vector - Manual (Page 10)

Pressing the FUNCTION button begins the menu cycle of STATS, TUNE BAR, E, REMOTE (only if optional
digital output is installed). Press the SELECT button when the desired function annunciator appears in the
display.
FUNCTION-Model D200P
Pressing the FUNCTION button begins the menu cycle of CH AB RATIO, STATS TUNE BAR LOG E
REMOTE, TRIG A TRIG B.
Pressing SELECT when CH AB RATIO appears allows selection of channel A, channel B, the ratio of A/B or
B/A.
Pressing SELECT when STATS TUNE BAR LOG E REMOTE appears allows selection of the statistics
mode, analog tune bar, log units, display in scientific notation, RS232 and IEEE488 configuration.
Pressing SELECT when TRIG A TRIG B appears allows selection of the trigger channel.
FUNCTION-Model D200PC
Pressing the FUNCTION button when in channel A is identical to the D200P. Pressing the FUNCTION button
when in channel B begins the menu cycle of STATS, TUNE BAR, E, REMOTE. Press SELECT when the
desired function appears to activate it.
FUNCTION-Model D200C
Same as channel of D200PC.
SELECT
Activates a particular mode or function. Also turns the display backlighting on and off.
COUNT UP COUNT DOWN
Allows numeric entry into the display when in the calibration mode, statistics mode, or average energy mode.
CANCEL
If pressed during any menu cycle the indicator will return to its previous mode of operation. Pressing the
CANCEL button is also the exit out of the statistics mode and is used to zero the display.
7