Scientech S200 Vector - Manual (Page 9)

Operation
FRONT PANEL CONTROLS
RANGE
Pressing the RANGE button begins a cycle through 6 ranges in the pyroelectric channel or 5 ranges in the
calorimeter channel. In the pyroelectric channel if the 1 M
Ω input impedance is selected the range cycle is 2
m, 20 m, 200 m, 2, 20, AUTO. If the 50 Ω input impedance is selected, the range cycle is 2 µ, 20 µ, 200 µ, 2
m, 20 m, AUTO. In the calorimeter channel if a 25 mm calorimeter is connected the range cycle is 10 m, 100
m, 1, 10, AUTO (watts mode only). If a 50 mm calorimeter is connected the range cycle is 30 m, 300 m, 3,
30, AUTO (watts mode only). When the desired range appears in the display, press the SELECT button to
activate that range. When the AUTO range is selected, the indicator automatically selects the most
appropriate range with the greatest resolution. Therefore, as the displayed values reach a boundary, the
indicator will automatically switch to the next higher or lower range as appropriate. In a manual range,
-OF- will appear in the display if the input laser power or energy level exceeds the range capability.
MODE-
MODE-MODELS S200, D200P
Pressing the MODE button begins a cycle between MODE and CAL. Pressing the SELECT button when
MODE appears in the display
begins a cycle of VOLTS, ENERGY, AVG ENERGY, AVG POWER. Pressing the SELECT button when the
desired mode appears activates that mode. Pressing the SELECT button when CAL appears in the display
begins a cycle of V/mJ, V/J, ATTEN. Pressing the SELECT button when the desired calibration mode
appears activates that mode.
MODE-Model D200PC
Pressing the mode button when setting up channel A is the same as the S200 and D200P. Pressing the
mode button when setting up channel B begins a cycle of AVG POWER, ENERGY. Pressing the SELECT
button when the desired mode appears activates that mode.
MODE-Model D200C
Same as channel B of D200PC.
FUNCTION
FUNCTION-Model S200
6