SeaLand 712-TM09 Toilet - Manual (Page 5)

5
SeALAND ToILeT
BASe ASSeMBLy BAND CLAMp
fASTeNeR
SpRING
CARTRIDGe
WATeR vALve ASSeMBLy
Top vALve CAp
fILTeR SCReeN
WATeR vALve SCReWS
vALve BoDy
ShAfT
peDAL
CoveR
BAND CLAMp
SeAL
fLuSh BALL
CAM STRAp
DISK
SeALAND ToILeT BoWL, ReAR vIeW
(Model 712)
vACuuM
BReAKeR
WATeR vALve hoSe
CoNNeCTIoN
vACuuM BReAKeR/BoWL CoNNeCTIoN
TRouBLeShooTING
operation
. Twist white cap counterclockwise until it stops (A). Lift off
cap.
2. Slide switch from OFF to TEST to assure fresh batteries and
proper operation. In TEST mode, the “3/4 FULL” (left) and
“FULL” (right) lights should illuminate. The “LOW BATT” (center)
light will not illuminate. Slide switch to ON for operation. The
level indicator can be turned off if the toilet will not be used for
an extended time.
3. Replace white cap.
Indicator Lights
When the holding tank level reaches about 3/4 full, the yellow
“3/4 FULL” light illuminates.
When the holding tank is full, the red “FULL” light illuminates.
The holding tank should be emptied before the toilet is used again.
If the holding tank fills up and the indicator lights do not glow, the
probe ends may need to be cleaned. See CLEANING PROBES.
When emptying the tank, the indicator lights may remain lit until
after the effluent drains from the sensing probes. If the lights con-
tinue to remain lit after a few minutes, the probe ends may need
to be cleaned. See CLEANING PROBES.
Cleaning probes
. To remove probes from holding tank, twist off white cap and
set aside.
2. Twist and pull black probe body up to remove it from rubber
grommet. After cleaning probes, be sure to put probe back into
rubber grommet with the word “TOP” toward back of tank.
Batteries
When the batteries become weak, the red “LOW BATT” light will
illuminate. Replace with AA alkaline batteries, making sure to
position new batteries as shown.
TANK LeveL INDICAToR INSTRuCTIoNS