Shellab SMI12 - Manual (Page 5)

.
5 | P a g e
RECEIVING YOUR INCUBATOR
Before leaving our factory, all incubators are packaged in high-quality shipping materials to provide
protection from transportation-related damage.
When an incubator leaves our factory, safe delivery becomes the responsibility of the carrier. Damage
sustained during transit is not covered by the incubator warranty.
When you receive your incubator, inspect it for concealed loss or damage to its interior and exterior. If
you find any damage to the incubator, then
follow the carrier’s procedure for claiming damage or loss.
The unit should come with an Installation and Operation Manual, warranty card, and a Certificate of
Compliance.
I
NSPECTING THE
S
HIPMENT
Carefully inspect the shipping carton for damage. Report any damage to the carrier service that delivered
the incubator. If the carton is not damaged, open the carton and remove the contents.
Verify that the correct number of shelves, shelf slides, and leveling feet have been included (see the
following table for quantities).
Included accessories
Model Shelves Shelf Slides Leveling Feet
SMI2, SMI7
(GI2, GI7)
2 4 4
SMI6
(GI6) 3 6 4
SMI11, SMI12
(GI11, GI12)
6 12 4
Carefully check all packaging before discarding. Save the shipping carton until you are sure everything
works properly.
R
ETURNING THE
S
HIPMENT
If you must return the incubator for any reason, first contact your service representative for authorization
(RMA). You must provide the data plate information. See Recording Data Plate Information below.
R ECORDING D ATA P LATE I NFORMATION
Locate the data plate at the back of the incubator. The data plate contains the incubator model number
and serial number. Enter this information below for future reference.
Date Plate Information
Model Number
Serial Number
Part Number
Voltage