SIG SAUER MOSQUITO - Manual (Page 16)

Conversion
15 US 06.01
7.2 Conversion to Standard version
Procedure:
1. Disassemble the pistol (see chapter 9.1).
2. Exchange the barrel of the Standard version
1a with the barrel of the Silencer version 1c
(see chapter 7.3).
3. Reassemble the pistol
(see chapter 9.3).
4. Install the threaded cap 81
(see chapter 7.2.2).
7.2.1 Removing the threaded cap
Procedure:
1. Release the threaded cap 81 using the
assembly wrench 82 provided and remove it.
7.2.2 Installing the threaded cap
1. Attach the threaded cap 81 and tighten it with
the assembly wrench 82 provided.
7.3 Exchanging the barrel
Procedure:
1. Release the screw 66 and remove the
takedown lever 16.
2. Release the screw 58 of the frame 15 and
remove it.
3. Lift the barrel 1a and take out the takedown
lever insert 25.
4. Insert the takedown lever insert into the barrel
1b (Sport version) or
1c (Silencer version).
5. Insert the barrel into the frame.
Notice:
Before inserting the screws 58 and 66 apply
Loctite to the thread.
Fig. 9
82
81
Fig. 10
CAUTION!
Possible damage to the pistol
• Do not tighten the screws too tight.
58
16
1a
15
25
66