SIG SAUER MOSQUITO - Manual (Page 20)

Maintenance
19 US 06.01
9.3 Pistol assembly
Procedure:
1. Inspect the pistol interior and remove any
foreign matter.
2. Slide recoil spring 3 onto the spring guide 2.
3. Insert spring guide with recoil spring into the
frame 15. The flat portion of the recoil spring
guide faces the rear of the pistol.
4. Slip slide over the recoil spring and recoil
spring guide.
5. Retract the slide fully to the rear and down until
the slide guide can click into the frame guide.
6. Slowly move the slide forward until closed.
7. Install the threaded cap of the Silencer version
(see chapter 7.2.2), resp. the counterweight of
the Sport version (see chapter 7.1.2).
8. Rotate the takedown lever counter clockwise
180° until it points towards the rear of the
pistol.
Note:
The pistol is unloaded and decocked.
Fig. 18, Cleaning Sport version
Fig. 19, Cleaning Silencer version
4
1b
2
15
51
79
80
3a/b
4 3a/b
1c
2
51 82
81
CAUTION!
Frame, recoil spring guide and recoil spring
are loosely connected
Possibly damage to the pistol and bodily
harm
• Careful handling of the slide and the parts
connected to the recoil spring.