SilentKnight SD505-6SB 6 Sounder Base - Manual (Page 2)

2
7550 Meridian Circle, Ste 100
Maple Grove, MN 55369-4927
763-493-6455 or 800-328-0103
Fax: 763-493-6475
www.silentknight.com
© 2008 Honeywell International Inc. PN 151191 Rev C
Auxiliary Power Wiring
The SD505-6SB can use aux power from a UL
listed, power-limited 24 VDC source. Figure 4
shows how to connect the SD505-6SB to an
auxiliary power supply.
Figure 4: Auxiliary Power Connections
Note: Auxiliary power is supplied by a regulated UL
listed power supply for Fire Protective Signalling
Systems.
Auxiliary Power Using
Flexput™ Circuits
The following describes how to use the Flexput
circuits as the auxiliary power source:
1. Connect the aux power wires to the Flexput
terminals using “X” terminals as positive,
and “O” terminals as negative power. See
Figure 5.
Figure 5: Flexput Auxiliary Power Output
2. Configure the auxiliary power output for
constant output through programming (refer
to Section 7.4 of the IntelliKnight 5820XL or
IFP-1000 Analog/Addressable Fire System
(P/Ns 151209 & 151139).
Mounting
This section contains instruction on how to
mount the SD505-6SB. Refer to Figure 6.
Figure 6: Mounting the SD505-6SB
1. Mount the extension base using the #8 1-1/2
screws through any of the extension base
mounting holes. (See Figure 6.)
2. Connect Aux power and the SLC loop as
shown in Figure 1, Figure 2 and Figure 4.
3. Connect wiring harness (P/N 140675) to the
smoke base and SD505-6SB as shown in
Figure 6.
4. Attach the smoke base to extension base (P/
N 120505) using the #8 1/2” screws, through
the smoke base mounting standoffs.
(See Figure 6.)