SilentKnight SKE-V70 Module - Manual (Page 2)

SKE-V70 Module Installation Instructions
2
7550 Meridian Circle
Maple Grove, MN 55369-4927
763-493-6455 or 800-328-0103
Fax: 763-493-6475
www.silentknight.com
© 2005 Silent Knight PN 151305 Rev B
SILENT
KNIGHT
®
by Honeywell
Connecting the SKE-V70 to the
Main Control Panel
Connect the SKE-V70 to the main control panel
using the supplied wire harness. See Figure 3.
Note: Speaker outputs of the SKE-450 must not be used with the
SKE-V70 because supervision will not be provided at the
SKE-450.
Figure 3: Wire Harness Connection From the Main
Control to the SKE-V70
Connecting the SKE-V70 to the
SKE-ZN4 or -ZN6
If the optional SKE-ZN4 or -ZN6 zone splitter is
used in the system connect the wire harnesses as
described below.
Note: Speaker outputs of the SKE-450 and SKE-V70 must not
be used when using either the SKE-ZN4 or SKE-ZN6 in
combination with the SKE-V70 because supervision will
not be provided at the SKE-450 and the SKE-V70.
1. Connect one harness from the main control
to the SKE-V70 connector marked “FROM
CONTROL”. See Figure 3.
2. Connect the other harness from the SKE-
V70 connector marked “TO SPLITTER” to
the connector on the SKE-ZN4 or -ZN6 as
shown in Figure 3.
Class B (Style Y)
Figure 4 illustrates how to wire speakers to the
SKE-V70 using Class B (Style Y) supervision.
Figure 4: Class B (Style Y) Speaker Configuration
Class A (Style Z)
Figure 5 illustrates how to wire speakers to the
SKE-V70 using Class A (Style Z) wiring.
Figure 5: Class A (Style Z) Speaker Configuration
Electrical Specifications
Ground Fault Impedance To Any Terminal: 0 Ω
Standby Input Power: 27.4 VDC @ 10 mA
Alarm Input Power: 27.4 VDC @ 70 mA
Supervised
Power Limited
15 k Ω EOL
UL Listed
Model 7630
Supervised
Power Limited