Solvline PB2xxxUG - Manual (Page 12)

3) Set the COM port to 9600 bps, none parity, 8 data bit, and 1 stop bit.
4) Turn on the Portbase (By connecting the power line of Portbase to power).
5) Set the Portbase IP Address.
set ip User IP Address
6) Set the Subnet Mask (Default: 255.255.255.0) .
set mask User Net Mask Address
7) Set the Gateway IP Address(Default: 203.211.173.1) .
set gateway User Gateway Address
8) To confirm the over all setting values, use the command below.
set view
9) To write the Flash memory after altering, use the command below.
set save
10) After the environment settings are applied, you should restart the system
reboot
.
To remember the IP setting, write it down on the sticker below the Portbase
12