Solvline Eddy DK - Manual (Page 141)

Eddy DK Programmer Guide
141
9.2.3 System recovery execution via USB
1) Tu rn off DK board.
2) Connect USB cable to both the DK board and PC.
3) Set USB as a standby mode by pulling the right side switch down from the dip switch on the DK board.
[ Eddy-CPU DK:S6] [ Eddy-S4M DK:S1]
4) Turn on DK board.
5) After 5 seconds change flash writing mode by pulling up both of S6 Dip switch on DK board.
[ Eddy-CPU DK:S6] [ Eddy-S4M DK:S1]
6) Start upgrade by double-clicking Eddy_burning_SerialFlash.bat file. You need to wait some time for seeing the log
File after executing the batch file.
7) With the successful log message as below you can check the result of the upgrade. If you cannot see
the successful log message, you can refer to next chapter to fix the problem.
8) With the successful log message, confirm whether the new firmware works properly or not by rebooting Eddy DK
v2.1 board.
…
u-boot file: eddy-bl-2.x.x.x.bin
…
-I- === Load the bootstrap: xxxxflash_at91sam9xxxek in the first sector ===
GENERIC::SendFile ./eddy-bs-2.x.x.x.bin at address 0x0
…
ON
1
ON