Soniclean Digital Benchtop Ultrasonic Cleaners - Manual (Page 4)

DO:
●
operate in normal room temperatures around 25C.
●
use adequately and correctly earthed mains electricity supply with correct
voltage to your ultrasonic cleaner. Check with qualified electrician if in doubt.
●
fill at least 2/3 full or ¾ full on heated models.
●
use a basket/tray/rack to prevent contact between objects and the tank.
●
ensure all splash marks and spillages are cleaned off the unit immediately
OPERATING YOUR UNIT
CONTROL PANEL
PREPARATION
1 Set the unit on level surface to enable liquid to drain out completely.
2 Check for the correct voltage. (See back label on the unit) Plug in your ultrasonic
cleaner and switch on at the power point.
3 Close the drain valve and fill the tank with cold room temperature or tepid water to
2/3 full, or ¾ full for heater models.
BASIC SETTINGS
4 Simply press Start or Degas keys to commence these cycles. To cancel cycles press
Stop key.
5 To change the timing cycle press More or Less keys to increase or decrease cycle
time. Factory default is 15 minutes for clean and 5 minutes for degas.
6 Once cycle times are optimized simply press Start or Degas and display shows the
selected optimized time cycles during countdown.
DEGAS
7 Add a specified amount of recommended detergent to the ultrasonic tank. For the
best results first start the machine and then sprinkle the detergent along the insides of
the tank.
8 Press Degas to expel air bubbles from the water. This takes 1-5 minutes, depending
on water quality. Degassing is complete when cavitation surface ripples become evident.
9 Adjust time using More or Less keys if necessary or press Start .
Issue date: 190913-1