Sonics VC5040PB - Manual (Page 5)

2
PREPARATION FOR USE
1. Mount the converter / probe assembly in a stand. Secure the clamp to the 1 ¼”
(32 mm) diameter converter housing only. Do not secure the clamp to any other
portion of the converter / probe assembly.
2. Connect the converter to the power supply.
3. Rotate the AMPLITUDE control fully counterclockwise.
4. Connect the 24 volt power supply to the ultrasonic power supply.
5. Plug the 24 volt power supply into the electrical outlet. If the ON/OFF switch
illuminates, depress it to de-energize the unit.
NOTE
If the probe is not attached to the converter observe the following:
a. Check for cleanliness the mating surfaces of the converter and
probe, as well as the threaded stud and hole.
b. Hand assemble the probe to the converter, and using two
wrenches, tighten securely.