Sonics VC50 AT (1990) - Manual (Page 10)

10
NOZZLE CLEANING
Whenever possible, flush the nozzle with water or an appropriate solvent after use.
Ensure that there is no material build- up on the atomizing surface. If material build-up is
present, clean the atomizing surface with steel wool.
Clean the inside of the atomizing nozzle with a pipe cleaner or a small round brush. Do
not under any circumstance use a drill to remove material build- up.
RETURN OF EQUIPMENT
It is suggested that an Ultrasonic Atomizer in need of repair be sent back to the factory.
In order to receive prompt service; always contact the factory before returning any
instrument. Include date of purchase, model number and serial number. For instruments
not covered by the warranty, a purchase order should be forwarded to avoid unnecessary
delay. Care should be exercised to provide adequate packing to insure against possible
damage in shipment. The Ultrasonic Atomizer should be sent to the “Service
Department” with all transportation charges prepaid and return of shipment indicated.
Please obtain a Return Authorization Number prior to returning the instrument.
IMPORTANT
I CERTIFY THAT THE ULTRASONIC ATOMIZER AND / OR ACCESSORIES RETURNED FOR
REPAIR ARE FREE OF ANY BIOHAZARDOUS OR RADIOACTIVE MATERIAL AND ARE
SAFE FOR HANDLING.
DO NOT RETURN ANY EQUIPMENT UNLESS SUCH CERTICATION CAN BE MADE.