Sonics VC500 - Manual (Page 11)

11
5. Set OUTPUT CONTROL to “4”.
6. Release ON/OFF/TUNE Switch.
7. With a dual output 500 watt Ultrasonic Processor, if two converters are going to
be used simultaneously, connect the second converter cable to connector.
NOTE
If minimum reading cannot be obtained, check unit without the probe to ascertain whether the
power supply or probe is at fault.
CAUTION
On dual output 500 watt Ultrasonic Processors manufactured prior to June 1985, a
switch is located above the tuning control.
Check that the switch is in the down position.