Sonics FC - Manual (Page 11)

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
10
I N S T R U C T I O N M A N U A L • M O D E L F C P O W E R S U P P LY
ELECTRICAL CONNECTIONS
The standard cable supplied with a “Sonics” press is 10 feet. Optional
extension cables are available up to 15 feet without modification.
When making the initial electrical connections, make sure the power is
disconnected and follow these precautions.
1. Do not strain or kink the cables. When going around corners, allow as wide
a bend as possible. Do not run the cables parallel to any power line within
a distance of less than 1 foot (305mm).
2. To prevent the possibility of an electrical shock, ensure that the power
supply line cord is properly grounded. Also make sure that the voltage
rating of the electrical power source matches the power supply
requirement (refer to the “Power Specifications” table on preceding page).
3. Check with your electrician if you have any wiring questions.
NOTE: Do not plug
the power supply into
an electrical outlet
until all other
connections have
been made.