Sonics FM - Manual (Page 32)

Use the numerical keys to enter in the new pressure value. When the desired
pressure is displayed on the LCD screen, press the ENTER key. The LCD
screen display will show the following:
To set a new Booster Gain ratio, use the CE and numerical keys in the same
manner described above for recording the Pressure value. Upon completion,
press the ENTER key and the LCD display will change to:
To record a new Horn Number, follow the same procedures as for recording
Pressure and Booster Gain.
JOB SEQUENCE
Once jobs have been stored, they can be sequenced in accordance with
application requirements. Saved jobs can be sequenced in any order and
may be repeated in the sequence up to a maximum of 9 steps. Each job in
the sequence is considered one step, with a maximum of 9 steps in a
sequence before the sequence is repeated. The weld line report to the
printer/CRT will include the step number in the sequence. The LCD screen
display will indicate the step in the sequence that will be performed in the next
weld operation.
To use the job sequence feature, press the INFO key 7 times (from the
READY 1 mode). The LCD display will show the following:
To sequence, first press the CE key. The LCD display will change to:
Use the numerical keypad to enter in the numbers corresponding to the
sequence of stored jobs to be utilized. For example, a display of “SEQUENCE
1324182” will sequence Job l, then Job 3, Job 2, and so on. If the system
does not respond to (and display) an entry, it is because there is no job saved
under that number.
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
I N S T R U C T I O N M A N U A L • M O D E L F M P O W E R S U P P LY
31
P R E S S U R E 0 . 0 0 P s i g
HORN NUMBER: 000000 __
S E Q U E N C E O F F
S E Q U E N C E
B O O S T E R G A I N = 0 . 0 0 __