Installation, Electrical power requirements, Setting up – Sonics GXL User Manual
Page 10
I N S T A L L A T I O N
ELECTRICAL POWER REQUIREMENTS
The power supply requires a fused, single-phase, standard 3-terminal
grounding type receptacle capable of supplying the requisite voltage and
current. Refer to the table below for power specification.
SETTING UP
The power supply is a free-standing assembly. It should be installed in a
clear, uncluttered location that is free from excessive dirt, dust, corrosive
fumes, and temperature and humidity extremes. The selected installation site
should be near the electrical power source and away from equipment that
generates abnormally high electrical transients. Observe the following
additional instructions when installing the equipment:
a. Allow at least 6 inches (152.4mm) at the rear of the power supply for cable
connections.
b. Position the power supply so that the front panel controls are visible and
readily accessible.
c. The power supply is air cooled; allow sufficient space around the
assembly to ensure adequate ventilation. If the power supply must be
housed in a confined space, forced air cooling may be necessary to keep
surrounding air within acceptable ambient temperature limits. Periodically
check the ventilation grille and clean as necessary.
¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥
¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥
I N S T R U C T I O N M A N U A L • M O D E L G X L P O W E R S U P P LY
9
The line cord of the
controller/power
supply is equipped
with a 3-prong,
grounding plug. Do
not, under any
circumstances,
remove the ground
prong. The plug must
be plugged into a
mating 3-prong,
grounding type outlet.
NOTE: If power
supply is to be run
continuously, air
cooling of the
converter and horn is
required. Use clean,
dry compressed air
filtered down to 5
microns (supplied to
converter fitting – see
POWER SPECIFICATIONS
Power Rating/
Model
Frequency
115 vac
230 vac
GXL400-40
400w - 40 kHz
15 amps
10 amps
GXL800-40
800w - 40 kHz
15 amps
10 ampL
GXL1200-20
1200w - 20 kHz
15 amps
10 amps
GXL1700-20
1700w - 20 kHz
N/A
20 amps
GXL2200-20
2200w - 20 kHz
N/A
20 amps
GXL3500-20
3500w - 20 kHz
N/A
30 amps
GXL2200-15
2200w - 15 kHz
N/A
20 amps
GXL3500-15
3500w - 15 kHz
N/A
30 amps
GXL4500-15
4500w - 15 kHz
N/A
30 amps
Go To Top Of Document