Sonics GXE - Manual (Page 36)

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
I N S T R U C T I O N M A N U A L • M O D E L G X E P O W E R S U P P LY
34
Item 5: The maximum percent power number is next in line at positions 36
through 38 with a space at 39. This number is the maximum percent of
power developed during the last weld cycle. The label “%Pmax” does not
change case as the control items can for time, distance (Model GXL only)
and energy. It is not a control parameter, just a label for text readability.
005647 00.48 sec 0.025 in 000130 J 045 %Pmax Alarms T:-- D:-- E:-- J06 -----
Item 6: Any alarm violations for time, distance (Model GXL only) or energy
will be sent in the following positions as L or H in place of the “--” shown in
the sample line. The dashes are used to hold the place when there are no
alarm items so the “T:-- D:-- E:--” reading indicates that there were no alarms
during the last weld cycle. (Distance controls are not available on Model GXE
so the distance alarms will always print as “D:--.”) The low alarm, high alarm
order is always the same for time, distance and energy (examples: T:L- T:-H
or T:LH ). Time alarms are at positions 57 and 58; distance at positions 62
and 63; and energy at positions 67 and 68. Note that it is possible for a weld
cycle to have both high and low alarms at the same time depending on the
alarm settings (see page 18). High and Low alarms are set and examined
independently.
005647 00.48 sec 0.025 in 000130 J 045 %Pmax Alarms T:-- D:-- E:-- J06 -----
Item 7: The next item represents the last job number that was saved or
recalled from the job storage memory. There are 15 jobs numbered 1 through
15 so this item is transmitted as 01 through 15 or “--” if job data has not been
set (first power up). The “J” label is used for readability of the job data
number. When an automation system is using the remote job change option
between weld cycles, the print line can be used as verification of the recalled
job for the last weld cycle. The job data number is located at position 71
through 72.
005647 00.48 sec 0.025 in 000130 J 045 %Pmax Alarms T:-- D:-- E:-- J06 -----
Go To Top Of Document