Two isolated loop supplies, I/o timing diagram – automation controls, I/o timing diagram – automated controls – Sonics GXE User Manual

Page 41

Advertising
background image

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

I N S T R U C T I O N M A N U A L • M O D E L G X E P O W E R S U P P LY

39

TWO ISOLATED LOOP SUPPLIES

Two isolated non-regulated 24 VDC supplies (50 ma max) are available on

the digital I/O connector and may be used for the I/O loop power. These are

low level supplies and cannot be used to power relay inputs or outputs! They

should be used for LED indicators or transistor type input cards if the PLC

does not provide low level DC power for this purpose.

The first supply is available on connector J3 pin 1 (+24 VDC isolated supply

#1; cable wire – black) and J3 pin 2 (+24 VDC isolated supply return #1; cable

wire – white). The second supply is on J3 pin 3 (+24 VDC isolated supply #2;

cable wire – red) and J3 pin 4 (+24 VDC isolated supply return #2; cable wire

– green).

See schematic drawing on page 46 for more detail.

I/O TIMING DIAGRAM – AUTOMATION CONTROLS

The cycle begins with the impulse contact to start a cycle (note that the

impulse signal is not part of the configurable inputs and outputs for

compatibility with existing product lines). If the system is using external job

selection, the job address lines must be stable 50 ms prior to the impulse

contact and remain stable until the cycle is underway as indicated by Ready

going low (false). The Good Part/Bad Part lines are also cleared as the cycle

begins.

When the weld cycle is complete, the Good or Bad part signal is set prior to

the system returning to the ready condition. The impulse (and Palm Button

signals) must all be released to complete a cycle and return the Ready

Signal.

See schematic drawing on page 47 for more detail.

Go To Top Of Document

Advertising