Sound Oasis S-5000 - Manual (Page 5)

A-3
To avoid distortion created by such sources, it is advised that you
place the unit as far away from such sources as possible.
7. Do not apply excessive force when using any switches or controls.
8. The unit should be connected to a power supply only of the type
described in the operating instructions or as marked on the unit.
9. Precautions should be taken so that the grounding or polarization
means of the unit are not defeated.
10. Power supply cords should be routed so that they are not likely
to be walked on or pinched by items placed on or against them,
paying particular attention to cords at plugs, convenience
receptacles and the point where they exit from the unit.
11. The unit is equipped with an attachment plug with overload
protection. This is a safety feature. If replacement of the plug is
required, be sure the service technician has used a replacement
plug specified by the manufacturer that has the same overload
protection as the original plug.
12. The unit should be cleaned only as recommended
in the instructions.
13. The power cord of the unit should be unplugged from the outlet
when left unused for long periods of time.
14. The user should not attempt to service the unit beyond that
described in the operating instructions.
15. Do not attempt to clean the unit with a chemical solvent as this
might damage the finish. Use a clean, dry cloth.
Note:
• Operate controls and switches as described in the manual.
• Before turning on the power, make certain that the power cord is
properly connected to the electrical outlet.
• When moving the unit, be sure to first unplug the power cord.
• Avoid placing this unit in areas that are exposed to direct sunlight
or close to heat-radiating products, such as electric heaters. Do not
place unit on top of stereo equipment that radiates heat.