StarTech.com ST12MHDLAN - Manual (Page 9)

Instruction Manual
6
Hardware Reset Procedure
NOTE: If video signal does not appear on the display a hardware reset can be
performed on the Transmitter Unit, or individual Receiver Units.
1. Press the reset button on the device using a pin point tool, such as a ballpoint pen
or a bent paper clip.
EDID Copy
EDID allows the video source to output the most ideal signal to the video display. The
“EDID Copy” function on the ST12MHDLANRX ensures that EDID is still active through
the Ethernet extender.
NOTE: If you using multiple receivers the EDID can only be copied from one unit, the
signal customized for that display will be applied to all displays connected through
additional receivers.
1. Disconnect the power cable from the Receiver.
2. Hold down the F2 button
3. Reconnect the Power while holding down the F2 button
4. Release F2 button after the power has been reconnected for 12 seconds (the
Network Status LED flashes yellow), EDID is now active through the
Ethernet extender.
Factory Default Setting
1. Disconnect the power cable from the Transmitter/Receiver.
2. Hold down the F1 button
3. Reconnect the Power while holding down the F1 button
4. Release F1 button after the power has been reconnected for 17 seconds (the Link
OK POWER LED flashes green and blue)
5. Reconnect the Power again.