StarTech.com ST121UTPMINI - Manual (Page 6)

Instruction Manual 3
Installation
Transmitter Unit
1. Attach the Transmitter unit to the VGA source’s VGA output connector.
2. If using audio, connect the 3.5mm audio cable to the audio output connector.
3. To power the Transmitter unit, connect the integrated USB cable to an available USB port on
the video source device.
4. To test the VGA signal to the Transmitter unit, turn on the VGA source and observe the LED
indicators. The Video Sync LED should light up solid, if a good video signal is detected.
Receiver Unit
1. Attach the Receiver unit to the display’s VGA input connector.
NOTE: If the display has a VGA input that makes directly attaching the Receiver unit
difficult, use an appropriate length VGA extension cable
(i.e. StarTech.com ID: MXT101HQ3).
2. If using audio, connect the 3.5mm audio cable to the display’s audio input, or separate audio
receiver/speaker system.
3. To power the Receiver unit, connect the included DC power adapter.
4. The Video Sync LED should start blinking, as no video source is connected to the Receiver
unit yet.
Video Sync
LED
RJ45 Link
LED
RJ45
connector