StarTech.com STUTPWALL - Manual (Page 5)

2
Installation
Transmitter Unit (STUTPTXWAL)
Front View
* picture may vary from actual product
DE-15 Female Connector •
Power LED •
Control H/V signal inverting switch •
The default setting of H-INV is “OFF”. If H-INV is set to “ON”, the •
horizontal signal output is adjusted. H-INV on the receiver must
also be set to “ON”.
The default setting of V-INV is “OFF”. If V-INV is set to “ON”, the
•
vertical signal output is adjusted. V-INV on the receiver must also
be set to “ON”.
Use this setting when noise or sync issues are detected in the
•
signal transfer.