StarTech.com STUTPWALL - Manual (Page 7)

4
The default setting of H-INV is “OFF”. If H-INV is set to “ON”, the •
horizontal signal output is adjusted. H-INV on the transmitter
must also be set to “ON”.
The default setting of V-INV is “OFF”. If V-INV is set to “ON”, the
•
vertical signal output is adjusted. V-INV on the transmitter must
also be set to “ON”.
Use this setting when noise or sync issues are detected in the
•
signal transfer.
Rear View
* picture may vary from actual product
Power Connector •
RJ-45Female Connector •
Hardware Installation
Turn off the PC and remote monitor. 1.
Connect STUTPTXWAL Transmitter unit DE-15 female input 2.
connector with DE-15 male to male cable to PC video card.
Connect STUTPTXWAL Transmitter and STUTPRXWAL Receiver
3.
unit together with CAT5 cable.
Connect STUTPRXWAL Receiver unit DE-15 female connector with
4.
DE-15 male to male cable to monitor.
Connect the power adapter on each unit.
5.
Turn on the monitor and PC. 6.