StarTech.com RKCOND17HDGB - Manual (Page 8)

Instruction Manual
5
6. Install three of the included 6mm Flat Screws to secure the console to the bracket.
Repeat on the other side to complete the installation.
PC / Server Connection
1. Turn off the PC / Server you are connecting to the console.
2. Using one of the included cable sets, connect the appropriate video (VGA / DVI)
connector to the video output of your PC / Server. Then connect either the PS/2
keyboard/mouse connectors, or use the USB interface.
3. Connect the other end of the cables to the rear of the console.
NOTE: Move the PS/2-USB Selector Switch on the rear of the console to either side
to select your desired interface
4. Connect the USB Hub connector using one of the included USB A-A cables to the
USB connector on your server / KVM switch to enable the front USB hub ports and
fingerprint reader (optional).
5. Connect the AC to DC power adapter to the power inlet on the console and then to
a power outlet.
Connecting to a KVM Switch
When cascading with a KVM switch, KVM Module can be used to control additional
computers from the console. The connection is exactly the same as is shown above
(see PC / Server Connection section above). The only difference is the connection
would be made to the “CONSOLE PORT” of the KVM switch instead, of a computer.