Adjustable length extension column – SunBriteTV SB-CM46A12 User Manual
Page 6
SB-CM46A12
Installation Instructions
6
ADJUSTABLE LENGTH EXTENSION
COLUMN
1.
Install adjustable column (A) into plate. (See Figure 4)
Securely tighten column.
•
Ensure column (A) engages four full threads into plate.
•
Ensure cable access opening is rotated to desired
position (optional installation, column (A)).
Figure 4
2.
Secure column (A) by tightening set screw (C) in plate using
3/16" hex key (D). (See Figure 4)
NOTE:
Two adjustment holes provided in interior (fixed)
column. Either adjustment hole can be used to provide
1" (25mm) adjustment increments.
3.
(Optional) Remove button head cap screw and supporting
washers from lower adjustment hole if an additional 1"
(25mm) adjustment increment is desired. (See Figure 5)
4.
(Optional) Replace button head cap screw and supporting
washers into upper adjustment hole to provide an additional
1" (25mm) adjustment increment. (See Figure 5)
Figure 5
5.
Adjust column (A) to desired length, then rotate and lock
into position. (See Figure 5)
NOTE:
Any locking slot can be used to provide 1" (25mm)
adjustment increments.
6.
Tighten adjustment screw using 3/16" hex key (D). (See
Figure 5)
7.
Tighten set screws on back of pipe using 3/16" key (D).
(See Figure 6)
NOTE:
Optional installation similar; not shown.
Figure 6
4 x
1
1
4 x
(A)
2
(C)
(B)
4
6
5
(A)
3
7
x 2
(rear view)