SunBriteTV SB-CM46A12 - Manual (Page 9)

Installation Instructions SB-CM46A12
9
Figure 13
Adjusting Display
CAUTION: Watch for pinch points. Do not place fingers
between moveable parts.
Adjusting Roll
1. Using a 9/16" wrench, loosen the Nylock roll adjustment nut
on back of mounting plate. (See Figure 14)
2. Tilt the faceplate left or right as required.
3. TIghten nut.
NOTE: Do NOT overtighten fasteners.
Adjusting Pitch
1. Adjust display to the desired pitch.
2. Using the 5/32" hex head wrench (E), tighten the pitch
adjustment screw to hold mount in position. (See Figure 14)
Figure 14
2
1
4
Pin in
"Closed"
position -
Move to
"Open"
position to
remove
display
Remove bolt
or padlock
if used
Pin in
"Open"
position -
Move to
"Closed"
position
after display
is removed
Roll
Adjustment
Nut
Pitch
Adjustment
Screw