SunBriteTV SB-CM32A12 User Manual
Page 8
SB-CM32A12
Installation Instructions
8
Head Assembly Installation
1.
Thread head assembly (F) onto adjustment column (A) until
hand tight. (See Figure 7)
2.
Adjust head assembly (F) position until Centris cup is facing
the desired position of the display. (See Figure 7)
Figure 7
3.
When head assembly (F) is properly positioned, secure
head assembly (F) to adjustment column (A) by installing
and tightening 5/16-18 x 3/8" set screw (G) using 5/32" hex
key (H). (See Figure 8)
NOTE:
If mount is being used to couple two pipes, use both set
screws when securing head assembly (F) to pipes.
Figure 8
Display Installation
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY AND DAMAGE TO EQUIPMENT! DO NOT
substitute hardware. Use only hardware supplied by
manufacturer!
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
ELECTRIC SHOCK OR DAMAGE TO EQUIPMENT! Screw
length must not exceed the depth of threaded mounting insert
in display.
WARNING:
OVERTIGHTENING OF SCREWS CAN
DAMAGE PARTS AND LEAD TO SERIOUS PERSONAL
INJURY AND DAMAGE TO EQUIPMENT! DO NOT over
tighten screws when installing interface bracket.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Using screws of
improper size may damage your display! Proper screws will
easily and completely thread into display mounting holes.
Ensure that screws are not too long.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Inadequate thread
engagement in display may cause display to fall! Back out
screws ONLY as necessary to allow installation of Centris
cup!
1.
Loosen the top two mounting screws on the back of the
display to prutrude 1/8" and remove the bottom two screws.
(See Figure 9)
Figure 9
2.
Align two screws in display back with upper teardrop
mounting holes in mounting plate and lower display until
screws are seated in lower area of teardrop mounting holes.
(See Figure 10)
CAUTION:
Do not let go of the television at this point. Hold
the television in place while proceeding to the next step!
1
(A)
Centris Cup
(F)
3
(G) x 1
(F)
3
(F)
(G) x 1
(H)
loosen
remove
to 1/8"
1
1