Sure Heat Altima 30, 38, 48 - Manual (Page 11)

BUILT-IN INSTALLATION
9
35.5”
Max.
29” Min.
B
D
E
C
*Gas
Cutout
*Ignitor cutouts
48” Min.
2”
Opening for
access door(s)
A
B
C
D
E
AGR30PF
30.5”
24”
11.125”
N/A
N/A
AGR38PF
38.5”
24”
11.125”
N/A
N/A
AGR48PF
48.5”
24”
11.125’
N/A
N/A
ASB2
12.5”
24”
11.125”
N/A
N/A
ASF
12.5”
24”
11.125”
N/A
N/A
AD-1
N/A
N/A
N/A
18.25”
18.5”
AD-2
N/A
N/A
N/A
36.125”
18.5”
*Gas connection cut out needs to be 4” wide x
9” long, set 2” back from front edge.
*Ignitor cutouts are equal to a standard electrical
outlet with a minimum depth of 2.5”.
*If using a backsplash apron or rear wall, locate
electrical service on the left hand side for rotis-
serie motor connection.
5”
5”
Grill
Maximum distance to
center of ignitor button
Ignitor plate installation
If a sideburner (ASB2) is purchased, add 12.5” to Dimension A. Side burner should be mounted on the
right side (as you face the grill). The gas connection opening must remain in the same location, under the
grill. DO NOT move location under the side burner. If mounted directly to the grill, the right ignitor
cutout/plate is not required, as the ignitor is contained in the sideburner. If mounted separately from the
grill, the right ignitor cutout/plate is still required for lighting the grill.
If a steamer/fryer (ASF) is purchased, add 12.5” to Dimension A. Steamer/fryer should be mounted on
the left side (as you face the grill). The gas connection opening must remain in the same location, under
the grill. DO NOT move location under the steamer/fryer. If mounted directly to the grill, the left ignitor
cutout/plate is not required, as the ignitor is contained in the steamer/fryer. If mounted separately from
the grill, the left ignitor cutout/plate is still required for lighting the grill.
Side cutouts are needed on each side to feed ignitor wires to
the ignitor plates and allow access to side gas connections.
(Size: 10”high x 5 long, set 1” back from front edge)
A