Sure Heat VFBC Firebox - Manual (Page 14)

Installation and Instructions
14
Read all the installation instructions for
the appliance before beginning the installation of
the blower kit – BL102.
BL102 Blower Installation
Step 1.
Carefully unpack the blower assembly and
completely familiarize yourself with the parts. Care
should be taken not to damage the fan blades.
NOTE: If you are uncertain or unclear with
any instruction or parts, stop and immediately
contact the seller or manufacturer listed on
these instructions for further explanation
and/or direction.
Step 2.
Locate the blower access cutout found at the rear
center of the hearth pan (floor). Next, remove
cover and prepare the blower by removing the
tape backing from the velcro on the blower
housing. Place blower assembly against the
back cutout with the blower outlet duct pointing
towards the rear/back of the unit. Then, press
firmly to attach the tape to the bottom of the
fireplace. (Fig. 13)
Step 3.
Locate the junction box cutout found on the right
side of the hearth pan. Rout the power cord under
the hearth pan and plug it into the receptacle outlet
found in the junction box. (Fig. 14)
Step 4.
Turn power back on and test the blower operation.
Step 5.
Replace blower cutout cover to original location
and position on the hearth pan.
Fig. 14
Blower outlet duct lines up with cut outs.
Remove cover
to install fan.
Fig. 13