Sure Heat VFBC Firebox - Manual (Page 4)

Product Features
4
Do not attempt to burn solid wood fuels, vented gas log sets, or any other combustible in this
unvented firebox. Also, do not install a vent-free gas log set in this firebox if the minimum
clearance and height requirements of the log set are too large for the firebox.
You have purchased a vent-free firebox. This installation manual will enable you to obtain a safe, efficient
and dependable installation of your vent-free firebox system.
Do not alter or modify the firebox or its components under any circumstances. Any modifications or alteration
of the firebox system, including but not limited to the firebox and accessories, may void the warranty, listings and
approvals of this system, and could result in an unsafe and potentially dangerous installation.
Before You Start
Carefully inspect the contents for shipping damage. If any parts are missing or damaged, immediately inform
the dealer from whom you purchased the appliance. Do not attempt to install any art of the appliance unless you
have all the parts in good condition.
Make Sure That You Have Received All Parts
Check your packing list to verify that all listed parts have been received. You should have the following:
1. Vent-Free Gas Firebox 3. Installation and Operating Manual
2. Canopy 4. Five (5) sheet metal screws for canopy.
What You Will Need For Installation
Tools
• Phillips screwdriver • Square
• Hammer • Saw and/or sabersaw
• Tee Joint • Electric drill and bits
• Level • Pipe wrench
• Measuring Tape • Piping complying with
local codes
• Pliers • Pipe sealant approved
for use with propane/L.P.G.
(resistant to sulfer compounds)
Building Supplies
• Framing materials
• Wall finishing materials
• Caulking material
(non-combustible)
• Fireplace surround materials
(non-combustible)
Notice:
Illustrations shown in this manual reflect "typical" installations with nominal dimensions and are for design
and framing reference only. Actual installations may vary due to individual design preferences. However,
always maintain minimum clearances to combustible materials and do not violate any specific installation
requirements.