Preset tab, Lead level, Lead pan – TC-Helicon VoiceLive Rack Full User's Manual User Manual
Page 78: Lead effect sends, Lead level lead pan lead effect sends, The edit button
77
The Edit Button
PRESET Tab
f LEAD LEVEL
This allows the overall lead (dry with Tone) voice
level to be reduced for the current preset. There
are additional LEAD LEVEL parameters in the ef-
fect tabs (µMOD, DELAY etc) which may be used
to reduce lead level further but only when their
respective effect is active.
f LEAD PAN
Sets where your lead voice appears in the stereo
field for the current preset. This can be useful
when panning a Harmony voice to one side and
your Lead voice to the other.
f LEAD EFFECT SENDS
When set to PRE, your voice will be sent to the
µMOD, DELAY and REVERB effects independent
of the LEAD LEVEL setting. 100% wet effects can
be achieved when LEAD EFFECT SENDS is PRE
and LEAD LEVEL is OFF in any of the effects.
When set to POST, effect levels follow the LEAD
LEVEL value so the effects will stay in the same
balance with your voice when its level is adjusted.