TC-Helicon VoiceLive Manual - Manual (Page 49)

47
SONG MODE
Song Direct Mode
To enter Song Direct Mode, you need to be in Song Mode, then hold the DIRECT button (3) until
the LED text display flashes DRCT.
SA21
Above is an example of a Song Direct Mode LED text display
S
This character means that you are in Song Mode.
A
This character means that you are in Direct Submode as well as:
• If it’s an A,B, C or D then a Direct Step has just been recalled by pressing one of corre-
sponding top four DIRECT buttons. In this case holding one of the top four buttons will
change the mode of VoiceLive operation.
• If it’s a * then holding one of the top four buttons will program the current step to the button
held.
21
This indicates the current Song step.
Pressing the DIRECT buttons (1-4) will jump to the programmed step.
Holding the DIRECT buttons (1-4) will either program the current step to that Direct Button
(when the second LED character is a *) or change the mode of operation of VoiceLive.
PREVIOUS/NEXT buttons (5, 6) changes the Song step. When this happens the second char-
acter on the LED display changes to a *, indicating that a DIRECT button may be programmed.
Song Voice Mode
To enter Song Voice Mode, you need to be in Song Mode, then hold the VOICE button (4) until
the LED text display flashes voic.
SV21
Above is an example of a Song Select LED text display.
S
This character means that you are in Song Mode.
V
This character means that you are in Voice Submode.
21
This indicates the current Song step.
Pressing the VOICE buttons (1-4) will enable/disable the individual harmony voices.
Holding the VOICE buttons (1-4) will change the mode of operation of VoiceLive.
Pressing the PREVIOUS/NEXT buttons (5, 6) changes the Song step. The enabled/disabled
combinations of the voices are maintained as Song steps are changed.