TeeJet 500 SLURRY COMPUTER - Manual (Page 14)

S ETTINGS T EE J ET 500 S LURRY COMPUTER OPERATORS MANUAL
14
MACHINE SETTINGS
All settings that are related to the actual machine are encoded under the “Machine
settings” menu. A description of each menu item follows:
IMPLEMENT SENSOR
This setting is used to select how spreading is started and stopped.
The available selections are described in the following:
Key Description
Start/Stop key:
Spreading is started and stopped by pressing the start/stop key.
PTO sensor:
Spreading is started and stopped when pulses/no pulses are
received from a sensor fitted to the PTO axle.
Spreading stops when no pulses are received and visa versa.
Pump sensor:
Spreading is started and stopped when pulses/no pulses are
received from a sensor fitted to the pump.
Spreading stops when no pulses are received and visa versa.
Ext.
External sensor:
Spreading is started and stopped via signals from an externally
fitted sensor. Spreading stops when the sensor is active (input =
lo).
DISTRIBUTOR
The total number of outputs on the distributor plus whether the slurry from the
closed outlets is returned to the tank (Returns = ON) or distributed between the
other (open) outlets (Returns = OFF) is encoded here.
This information is necessary to calculate the total tons spread (Ton +) and the
present flow (Ton/min.) if the slurry is returned to the tank after passing through
the flow meter from the given number of outputs.
The number of outlets that are not used for spreading is encoded under “Operation
settings”, which is described on page 12.
Returns ON/OFF is changed by moving the cursor over the field and then pressing
the ENTER key.