TeeJet TASC-6100 - Manual (Page 79)

B-7
98-05018
R2
TASC 6100
A
ppndx-B
CE & S TANDARD V ERSION
4
MID-TECH
MIDWEST TECHNOLOGIES, INC.
A
B
C
SPEED
A+B
A+B+C BOOMS A
U
T
O
TEST ON OFF
AUTOMATIC TIP CONTROL TIP SELECTOR DISPLAY SELECTOR
INC.
DEC.
BOOMS
1 2 3
SPEED / BOOMS
UP DELAY DOWN DELAY
HIGH SET
PSI
LOW SET
ZERO
CAL.
SETUP
4 5
Manual Mode
®
MASTER
Fig. B-9. Auto Tip
Control Box
EXTERNAL DEVICE DATALINK TASC CONSOLE
RTS CTS
INVALID
EXTERNAL
DATA INVALID
CONSOLE
DATA INVALID
DATALINK
DATA
LOCAL
CONTROL EXTERNAL
ENABLE
DATA FLOW DATA FLOW
MIDWEST TECHNOLOGIES, INC.
MID-TECH
DATALINK INTERFACE
Fig. B-10. Data Link
console and usually receives 12 VDC power from the
vehicle's accessory electrical circuit.
A
UTO
T
IP
C
ONTROL
The TASC 6100 has additional capabilities that enhances its
operation with the 90-01006 Auto Tip Control System. This
allows the automatic control of up to three different sized sets
of nozzles, extending the speed and application rate ranges of
the system. Enhanced control of the displays allow simulta-
neous viewing of speed, pressure, and application rate.
E
XTERNAL RATE
C
ONTROL
Using the Mid-Tech Data Link, the TASC 6100 console is
capable of operating under the control of external rate
commands from a large variety of GPS/GIS and Field Control
systems.