TeeJet 854 Sprayer Control - Manual (Page 40)

www.teejet.com
35
854 Sprayer Control
Figure 5-5: Density Value
DenS
1.28
Tip.Selection
Select the appropriate color of the spray tip being
used.
• Use the PLUS or MINUS keys to move
the flashing arrow to the tip’s corresponding
color tab.
The arrow should be located over the matching
color of the tips being used (tips must be ISO color
coded). The flow rate of the tip in GLM (LPM) at 40
psi/2 bar will be displayed on the lower right corner
of the screen. Press the PROGRAM key to select
the color tab and advance to the next step.
Figure 5-6: Tip Selection
0.40
40 20.0
6.0
Target.Application.Rate
Once the tip has been selected, the Target
Application Rate display will be flashing. If the
display rate is not flashing, press the PROGRAM
key three or four times until the Target Application
display starts to flash.
• Use the PLUS or MINUS keys to adjust
the target rate.
• Press the PROGRAM key to advance to the
next step.
Figure 5-7: Target Application Rate
0.40
40 20.0
6.0