TeeJet CenterLine 2.0 - Manual (Page 21)

CenterLine
Software Version 2.00
CenterLine 15
CenterLine Setup
Swath Manager 5
The Guidance setup parameter Swath Man is only an option when a Swath Manager 5 is con-
nected to the system. If a Swath Manager 5 is not being used ignore this section and continue to
“Width” on page 18.
To adjust the Swath Man setting, go to <GUIDANCE>, scroll with Up or Down until <SWATH
MAN> is displayed, and press Enter. Within the Swath Man menu there are four parameters,
%Overlap, Sections, Width 1-5, and Delay.
Figure 12: Swath Manager 5 Setup
Setting Description
% Overlap Boom Sections are activated and deactivated based on a percent-
age of boom in an applied area setting (0%, 50%, 100%).
Sections Enter the number of section 1-5 active on the system.
Width 1-5 Enter the width for each boom 1-5.
Delay Set a delay in seconds. This will act as a look ahead to turn booms
off and on when entering and exiting an applied zone
.
Table 2: Swath Man Menu Options
Figure 13: Swath Manager 5 Menu Options