Chapter 2 - setup, Quick start guide, First time start-up sequence – TeeJet CenterLine User Guide v2.02 User Manual
Page 9: Typical start-up sequence
CenterLine 2.02
98-05054 R6
5
CHAPTER 2 - SETUP
It is assumed that the CenterLine system has been properly installed. Refer to the following Center-
Line diagrams for system configuration.
QUICK START GUIDE
First Time Start-Up Sequence
1.
Turn ON power to CenterLine.
2.
The lightbar will perform a start-up sequence.
3.
The lightbar will display the current software version.
4.
The lightbar will display <START>.
5.
Using the Arrow buttons, scroll until <SETUP> is displayed on the lightbar. Press the
Enter button.
6.
Configure the CenterLine system by choosing the appropriate settings under <GUID-
ANCE>, <LIGHTBAR>, and <SYSTEM>. It is important to enter the correct swath width for
operation.
7.
Use the Arrow buttons to locate <TO START>. Press the Enter button. The operator will
return to the main menu.
8.
Once <START> is displayed on the lightbar, press ENTER to begin operation.
Typical Start-Up Sequence
1.
Turn ON power to CenterLine.
2.
The lightbar will perform a start-up sequence.
3.
The lightbar will display the current software version.
4.
The lightbar will display <START>.
5.
<START> will remain visible on the lightbar until the Enter button is pressed to begin oper-
ation or the Arrow buttons are pressed to select a menu option.
Arrow buttons
Enter button