TeeJet FieldPilot Install Case SPX 3150-3185 - Manual (Page 15)

14
www.teejet.com
FieldPilot ®
8. install steering disengage sensor
Remove the shield that covers the steering shaft. Drill a hole in the shield near the bottom left corner as shown.
Install bracket and sensor from kit (U) as shown. Glue 3 magnets to the shaft of the steering. Set the clearance
between the sensor and magnets to 1/8” and rotate the steering wheel in both directions to be sure that the
sensor does not contact the magnets or the shaft.
Figure 1-11: Installing the Steering Disengage Sensor
..