ThermoWorks 293-933 THERMADATA STAINLESS STEEL TEMPERATURE LOGGERS - Manual (Page 3)

SETTING UP THE LOGGER
• Unscrew the USB end cap and connect the logger to the PC’s USB
port directly or use the USB extender supplied.
• Select 'Logger Settings' from the drop-down 'Logger' menu.
• Enter a name for the logger in the Title (User ID) box.
• Select Com Port.
• Select temperature settings for 'over' or 'under' alarm using the drop-
down menu boxes.
• Select the data storage method – 'Stop when full' or 'Overwrite oldest
data'.
• Select a 'Start Delay' (note: for immediate start enter 0 hours, 0
minutes).
• Select the logging interval (note: the total time the log will last is
shown below the drop-down box).
• Click the 'Send Settings' button.
• Start the logger by clicking the 'Start button' on the PC screen.
• Re fit the USB end cap ensuring that the O Ring is not damaged,
twisted or trapped to ensure that the unit remains watertight.
READING THE LOGGER
• Be aware if you are using this data logger at high temperature, allow
the unit to cool before handling or connecting to the PC.
• Unscrew the USB end cap and connect the logger to the PC’s USB
port directly or use the USB extender supplied.
• Select 'Get Data' from the drop-down 'Logger' menu.
• 'View' readings using data window or graph window.
• Once you have downloaded the data re-fit the USB end cap ensuring
that the O Ring is not damaged, twisted or trapped to ensure that
the unit remains watertight.
(Full operating instructions for ThermaData Loggers are found in the
‘Help’ tab within the software.)