Tie Down Bench Structure - Manual (Page 4)

Bench Structure
GalvX #86910 / Galvanized #86928
Parts List
1 2x6 by 5' Wood or Composite Material (4)
2 1x4 by 12” Wood or Composite Material (2)
3 1/4" x 2.75" Flat Head Machine Screw (16)
4 1/4" x 1.5" Flat Head Machine Screw (4)
5 1/4" Nyloc Nut (20)
Eye bolts secure the receiver to the mounting base.
Once the holes are aliened hand tighten all eye bolts.
1
Installation Instructions:
1. The bolts securing the receiver to the bottom flange of the side panel may need to be loosened to allow proper
alignment and insertion of accessory support tubes.
2. Slide base of accessory tube into receiver until threaded holes align with holes in receiver.
3. Slide eye bolts through receiver side holes and screw into threaded holes in accessory base. Hand tighten all
eye bolts and then use screw driver shaft to tighten one half turn.
1
1
4
3 & 5
5
2
3
5
NOTE:
When installing the assembled
bench or attached bench seat and
back rest comments to installed
beach support tube. It is advised to
loosen bolts securing receivers to
the dock or deck. This will allow
slight movement in the receivers to
provide better alignment with the
bench structure.