Tii HNX-ET - Manual (Page 10)

P/N: 92226802
Rev A 5/08
10
Chapter 2 – Installation & Connection
2.1 System Requirements
HNP6L-ET and HNX-ET products are compatible with all operating systems with an Ethernet
port. Drivers are not required for this adapter. The supplied software configures the network
password and operates only with Windows operating systems.
Your computer must meet the below mentioned minimum requirements in order to use the
Configuration Utility:
• Windows Operating Systems:
• Windows 98SE, Windows Me, Windows 2000 ,Windows XP, or Vista with Ethernet
connection
• Pentium III 300 MHz MMX-Compatible PC or greater
• 128MB hard disk space and memory
• CD-ROM drive
2.2 Installation & Un-installation of Configuration Utility
Windows Operating Systems
Installation:
1. Connect the HNP6L-ET or the HNX-ET to the computer or the device with the Ethernet
cable.
2. Connect the HNP6L-ET or the HNX-ET to the Power Outlet.
3. Install the Configuration Utility. The Installation CD has an auto run feature. If the
Installation CD auto run fails, please run the Setup.exe file in the CD.
Note…
Your computer or the device to which you want to connect the HomePlug
Ethernet Adaptor must have an Ethernet port, i.e. a network card or a
network adaptor
.