Tii 605 Series - Manual (Page 15)

TII P/N: 92221501
10.6 Tool-less rocker accepts 22-24awg wire, lower ports
To terminate 18.5-24 AWG wire (driver bolt actuated).
10.7 Upper Ports of tool-less IDC rockers accept 22-24
AWG wire. Lift rocker to full upright position. Insert wires.
Lower rocker to full down position.
Note: There is no need to open the driver to terminate 22-24
AWG wire.
10.8 Lower Ports terminate 18.5-24 AWG wire. Raise
Driver bolt mechanism to full up position by turning driver
bolt counter-clockwise. Insert Tip/Ring pair into lower
ports. Lower Driver to Fully seated position.
10.9 Complete termination log.
10.10 Close door and check for proper sealing.
Lower Ports
Driver Bolt Mechanism Upper Ports
Tool-less IDC Rockers