Toa CR-413-6 - Manual (Page 14)

14
Step 2. Fit the supplied screw cover in the screw cover fittings.
Screw cover
(accessory)
Screw cover fitting attached to the component
(4 each on both sides)
4.5. 2202 Microphone Hanger (option) Installation
Install the optional 2202 Microphone Hanger to the rack's front frame to hang a handheld microphone.
Make holes in the desired position on the front frame referring to the figure below.
Note
Since no mounting screws are supplied with the microphone hanger, prepare two 4 x 10 tapping screws
separately.
12.6 (0.5)
2-ø3.2 (0.13)
[View with a microphone hung]
Microphone
Microphone hanger
[Mounting hole dimensional diagram
for the microphone hanger]
Unit: mm (inches)