Toa C-CH210FH - Manual (Page 8)

8
[Cross-sectional view of bushing]
Camera housing
Cable entry bushing
Rubber packing ring
(Attach securely)
Control cable or coaxial cable
6. CABLE ROUTING
1. From the two cable entry bushings provided on the housing’s bottom surface, select the one that is
appropriate for the diameter of cable to be used (control cable or coaxial cable).
2. Remove the selected bushing’s cap, and rubber membrane attached to prevent the entries of water and
dust.
3. Run the cable through the cap to route the cable to the inside of the housing through the bushing.
4. Rotating the bushing cap, adjust the bushing diameter so that no gap is created at the cable entry area of
the bushing.
Note
• Be sure to attach the rubber packing ring after routing the cable through the bushing.
• If a gap is created at the cable entry area of the bushing, wrap the self-adhesive type butyl rubber tape
around the cable to prevent rainwater from entering.
• Check to be sure that the routed cable is securely fixed by lightly pulling it.