Top Flite TOPA0706 - Manual (Page 22)

22
❏
8. Connect a T-fi tting to the air line and to the control
valve. Connect a third air line to the T-fi tting, routing it
out the air tank tray. Install the fi ll valve to the third air
line and install the fi ll valve in the air tank tray.
❏
9. Connect an 8" [203mm] long red and purple air
line to the air control valve. Install quick connects on
the other end of the two air lines. Important: Check
the wing as to which quick connect to install on which
color air line.
❏
10. A method used to mount servo wires and air line
tubing to a structure is to cut a strip of rubber band.
Position the rubber band over the wires and glue the
ends of it to the structure.
Fw 190 FACT
The Fw 190A-3 came with two 7.92mm MG 17
machine guns in the cowl, two 20mm MG 151/20E
cannons in the root of the wing and two 20mm
MG FF cannons in the outer wing panels.
INSTALL THE COWL
❏
1. Using a sanding bar or block with coarse sand
paper, sand a bevel around the edge of the plywood
fan ring. When properly sanded the ring should hold the
plastic fan tight against the front of the cowl.
❏
2. Use sand paper to roughen the back of the outer
ring of the plastic fan. Clean the sanded area with a
paper towel dampened with denatured alcohol.