Traxxas 68086-1 - Manual (Page 11)

SLASH 4x4 • 11
TRAXXAS TQ
i
RADIO & VELINEON POWER SYSTEM
Your model is equipped with the newest TQi 2.4GHz transmitter
with Traxxas Link ™ Model Memory. The transmitter has two
channels for controlling your throttle and steering. The receiver
inside the model has 5 output channels. Your model is equipped
with one servo and an electronic speed control.
MODEL WIRING DIAGRAM
to Motor
LED
EZ-Set Button
(On/Off Button)
Heat Sink
VXL-3s ELECTRONIC SPEED CONTROL
Traxxas High-Current
Connector (Male)
to Battery
Receiver cable
(RX wire)
Cooling Fan
Connector
(for optional use)
TRANSMITTER AND RECEIVER
Steering
Trim
Multi-Function
Knob
Throttle
Trigger
Throttle Neutral
Adjust
Steering Wheel
Power Switch Battery Compartment
Set Button
Menu Button
Red/Green Status LED
see page 30 for more info
Link
Button
LED
Sensor Expansion
Port **
V/T - Voltage/Temp Sensor Port**
RPM - RPM Sensor Port**
BATT/
CH5 - Battery/Channel 5*
CH4 - Channel 4*
CH3 - Channel 3*
CH2 - Speed Control
CH1 - Steering Servo
CH1 - Channel 1*
* Not used ** Accessory sensor port for use with the Telemetry Expander Module
(see Traxxas.com and included materials for more information)
Traxxas High-Current
Connector (Male)
to Battery
Brushless Motor
(see sidebar for proper
motor wiring)
Channel 1
Steering Servo
Channel 2
Electronic Speed Control
Cooling Fan Connector
(for optional use)
Antenna Motor Cap
** Accessory sensor port for use with the Telemetry Expander Module (see Traxxas.com and included materials for more information)
ESC/Motor Wiring Diagram
Velineon 3500 Specs
Type: Sensorless brushless
RPM/volt: 3500 (10-turn)
Magnet type: Ultra High-
Temperature Sintered
Neodymium
Connection type : 3.5mm bullet
Wire size: 12 Gauge
Max RPM: 50,000
Diameter: 36mm (1.42") (540 size)
Length: 55mm (2.165")
Weight: 262g (9.24oz)