Traxxas 68086-1 - Manual (Page 5)

SLASH 4x4 • 5
SAFETY PRECAUTIONS
LiPo Batteries
Lithium Polymer (LiPo) batteries are becoming popular for use
in R/C models due to their compact size, high energy density,
and high-current output. However, these types of batteries
require special care and handling procedures for long life and
safe operation.
WARNING: LiPo batteries are intended only for
advanced users that are educated on the risks associated with
LiPo battery use. Traxxas does not recommend that anyone
under the age of 14 use or handle LiPo battery packs without the
supervision of a knowledgeable and responsible adult.
Your model is able to use LiPo batteries with nominal voltage not
to exceed 11.1 volts (3S packs). LiPo batteries have a minimum
safe discharge voltage threshold that should not be exceeded. The
Velineon VXL-3s electronic speed control is equipped with built-in
Low-Voltage Detection that alerts the driver when LiPo batteries
have reached their minimum voltage (discharge) threshold.
It is the
driver’s responsibility to stop immediately to prevent the battery
pack from being discharged below its safe minimum threshold.
Low-Voltage Detection on the speed control is just one part of a
comprehensive plan for safe LiPo battery use.
It is critical for you,
the user, to follow all other instructions supplied by the battery
manufacturer and the charger manufacturer for proper charging,
use, and storage of LiPo batteries. Do not attempt to charge LiPo
batteries with the Traxxas charger included in this package. Make
sure you understand how to use your LiPo batteries.
Be aware
that Traxxas shall not be liable for any special, indirect, incidental,
or consequential damages arising out of the installation and/or use
of LiPo batteries in Traxxas models. If you have questions about
LiPo battery usage, please consult with your local hobby dealer
or contact the battery manufacturer. As a reminder, all batteries
should be recycled at the end of their useful life.
DO NOT ATTEMPT TO CHARGE LIPO BATTERIES OR ANY OTHER
TYPE OF BATTERY WITH THE INCLUDED TRAXXAS CHARGER.
Speed Control
• Disconnect the Batteries: Always disconnect the battery pack
from the speed control when not in use.
• Transmitter on First: Switch on your transmitter first before
switching on the speed control to prevent runaways and erratic
performance.
• Don’t Get Burned: The heat sink can get extremely hot, so be
careful not to touch it until it is cool. Supply adequate airflow for
cooling.
• Use Stock Connectors: If you decide to change the battery or
motor connectors, only change one battery or motor connector at
a time. This will prevent damage from accidentally mis-wiring the
speed control. Please note that modified speed controls can be
subject to a rewiring fee when returned for service. Removing the
battery connector on the speed control or using the same-gender
connectors on the speed control will void the product’s warranty.
• Insulate the Wires: Always insulate exposed or damaged wiring
with heat shrink tubing to prevent short circuits