TriangleTube TTP Series - Manual (Page 5)

operation and Code restrictions
3
ProduCT aPProvalS
-
Triangle Tube’s TTP Braze Plate Heat Exchangers
are UL approved.
- ASME is available as an option.
CodE CoMPlIanCE & rESTrICTIonS
• All piping and installations must conform with the
instructions listed in this manual and where applicable:
-
Local, state, provincial and national codes.
• Where recommendations in this manual differ from
local, state or national codes, the local, state or
national codes take precedence.
The heat exchanger is a single wall exchanger and com-
plies with National Standard Plumbing Code provided:
- Boiler / primary water (including additives) is
practically non-toxic, having a toxicity rating or
Class of 1 as listed in Clinical Toxicology of
Commercial Products, and
- Boiler / primary water pressure is limited to max-
imum 30 psig by approved relief valve.
Single wall heat exchangers are permitted under
Uniform Plumbing Code - Paragraphs L3.2 and L3.3 if
they satisfy all of the following requirements:
1. The heat transfer medium is potable water or con-
tains only substances, which are recognized as
safe by the U.S. Food and Drug Administration.
2. The pressure of the heat transfer medium is
maintained less than the normal minimum oper-
ating pressure of the potable water system.
3. The equipment is permanently labeled to indicate
that only additives recognized as safe by the FDA
shall be used in the heat transfer medium.
other heat exchanger designs may be permitted
where approved by the administrative authority.
oPEraTIng rESTrICTIon
Max. Operating Pressure (“E” model): 150 psig
Max. Operating Pressure (Double Wall): 362 psig
Max. Operating Pressure: 450 psig
Max. Operating Temperature: 350ºF
Min. Operating Temperature: (-)320ºF
Max. Steam Pressure: 15 psi
WaTEr / fluId QualITy rESTrICTIonS
•
pH limit should be maintained between 6 and 8 for
copper brazed exchangers
• pH limit (minimum) of 2 for nickel braze exchangers
•
Chloride level of less than 80 mg/l
• Sulfuric Acid or other types of corrosive acids
• Highly chlorinated water such as pool water is not
acceptable and will cause premature failure.
for pool and spa application with chlorine levels up
to 3000 ppm it is recommend to use the nickel
brazed heat exchangers.
Salt water or electronic chlorinating pools and spas
is not acceptable and will cause premature failure.
for salt water or electronic chlorinating pool and
spa applications contact Triangle Tube Technical
Services for assistance in sizing a titanium plate
heat exchanger.
rEfrIgEranT rESTrICTIonS
The copper brazed heat exchangers are not compatible
with ammonia (NH3) systems. The heat exchangers with
nickel brazing are suitable for this type of application.
douBlE Wall BrazE PlaTE HEaT ExCHangEr
The TTP-5 Series DW is a true double wall heat
exchanger that provides extra protection against leak-
age while providing leak detection. This system consists
of two stainless steel plates instead of one. In case of
internal damage to the plates, the chance of fluid cross-
contamination is reduced.
for sizing applications using a double wall heat
exchanger it is recommended to contact Triangle
Tube’s Engineering department.
NOTICE
NOTICE
NOTICE